Adding/Editing a Device
Table 62: Settings on the Add Device Page
DescriptionSetting
Enter a hostname for the device.
The hostname can include up to 24 characters in any language,
but it cannot include double-quotes ("), percentage sign (%),
ampersand (&), back-slash (\), or angle brackets (<>).
Hostname
Determine how you want the gateway to obtain its IP address.
• If you want the gateway to obtain an IP address through
DHCP, click Obtain an IP Address Automatically.
• To assign a static IP address to the gateway, click Use
the following IP address and enter the IPv4 address, the
subnet mask, and the default gateway.
The IP address, subnet mask, and default gateway must
be in the format ddd.ddd.ddd.ddd where ddd is a value
between 0 and 255 (except 0.0.0.0).
IP Settings
To enable DNS for the gateway, check the Enable DNS
resolution check box and enter the primary and secondary DNS
servers.
The IP addresses of primary and secondary DNS servers must
be in the format ddd.ddd.ddd.ddd where ddd is a value between
0 and 255 (except 0.0.0.0).
For DNS, make sure that you map the IPv4 address of
the Cisco Business Edition 3000 server to the hostname
on the DNS server. Cisco recommends that you update
the DNS server before you change the hostname or IP
address on the Network page.
Note
Enable DNS resolution
Click OK to add a device for the gateway. The newly
configured device is selected.
OK
Click Cancel to cancel the configuration and return to the
previous page.
Cancel
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
OL-27022-01 261
Adding/Editing a Device
To Next Page
Loading...
Need help?
General
