Cisco IE-3000-8TC Administration Guide

CHAPTER 34
PSTN Connection Settings
Impacted GUIs: Cisco Business Edition 3000 First Time Setup Wizard and Cisco Business Edition
3000 Administrative Interface.
The PSTN Connection Settings page allows you to configure additional PSTN connections, edit or delete
existing connections for the Cisco Business Edition 3000 server. The following table describes the settings
on the PSTN Connections page (Connections > PSTN Connections). Click PSTN Connections to view the
existing PSTN connections for the Cisco Business Edition 3000.
For DNS, make sure that you map the IPv4 address of the Cisco Business Edition 3000 server to the
hostname on the DNS server. Cisco recommends that you update the DNS server before you change the
hostname or IP address on the Network page.
If you update the IP address for the server, you need to reissue the CLI commands that are listed on the
Gateway page (System Settings > Gateway).
Caution
• PSTN Connection Settings, page 258
• Connection Type, page 259
• Device, page 259
• Adding/Editing a Device, page 261
• Provider, page 262
• Connection Settings, page 262
• Digit Discard Instructions Settings, page 308
• Calling Party Transformations Settings, page 310
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
OL-27022-01 257

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes