Cisco IE-3000-8TC Administration Guide

Common Configuration Concepts in Cisco Business Edition 3000
This section describes common configuration concepts in Cisco Business Edition 3000. In addition, this
section describes considerations that you should review before you configure the items:
• Network Settings, on page 35
• Dial Plans, on page 36
• Sites, on page 39
• Remote Management of Cisco Business Edition 3000 using Cisco OnPlus, on page 42
• Usage Profiles, on page 44
• Users, Departments, Phones, and Lines, on page 46
• Significant Behavior of SIP Trunk, on page 48
• Attendant Group, on page 50
• Hunt Lists, on page 51
• Call Pickup Groups, on page 51
• Example of Typical Deployment Model, on page 53
Network Settings
Your network settings include the IPv4 address or hostname of the server, the subnet mask and default gateway
for the server, the primary and secondary DNS server (if you use DNS), the link speed for the Network
Interface Controller (NIC) on the server, and the Message Transmission Units (Maximum Transmission Units,
MTU) for the network.
The network settings can be configured using one of the following methods:
• Through the Cisco-provided .xls data configuration file in the Cisco Business Edition 3000 First Time
Setup Wizard (for initial deployment)
• On the Network page in the Cisco Business Edition 3000 First Time Setup Wizard (if you are not using
the Cisco-provided .xls data configuration file during initial deployment)
• Under System Settings > Network in the Cisco Business Edition 3000 Administrative Interface (after
initial deployment)
• Through the configure.xml file (used primarily for troubleshooting when you cannot access the GUIs)
For more information, see the following sections:
• Working with the Cisco-Provided .xls Data Configuration File, on page 75
• Network Settings, on page 245 (for the Network page in the Cisco Business Edition 3000 First Time
Setup Wizard and Cisco Business Edition 3000 Administrative Interface)
• Using the Cisco Network Configuration USB Flash Drive, on page 457
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
OL-27022-01 35
Common Configuration Concepts in Cisco Business Edition 3000

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes