Step 6
Check the subnet mask by entering 120#.
Step 7
If necessary, change the subnet mask by entering 121#.
Step 8
Set the default gateway IP address by entering 131#, and then check the gateway IP address by entering 130#.
Step 9
Hang up the phone for the values to take effect.
Configure settings for TFTP on the SPA8800 GUI
Procedure
Step 1
Enter the web interface using the following URL: http://IP_Address_Of_SPA/admin/advanced
If you have problems accessing the SPA8800 device using the web interface, the issue may be a problem with
Cisco Discovery Protocol (CDP).
By connecting your laptop directly to the SPA8800 using an Ethernet cable, you can access the SPA8800
administrative interface to enable/disable CDP by choosing Network > Wan Status > VLAN Settings >
Enable CDP.
Step 2
Set the default password.
Step 3
Set the TFTP address for syncing the SPA8800 configuration from the Cisco Business Edition 3000.
Step 4
Click the Voice button on the upper left corner and then click the Provision tab, as shown in the following
illustration.
Figure 2: Provision tab
Step 5
In the Profile Rule field, specify the TFTP protocol and the IP address of the Cisco Business Edition 3000.
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
24 OL-27022-01
Components of the Cisco Business Edition 3000 System
To Next Page
Loading...
Need help?
General
