Cisco IE-3000-8TC Administration Guide

DescriptionSetting
Specify the time period (in ms) for Cisco Business
Edition 3000 to mark the channel idle on receiving
the incoming release from the gateway for the ingress
calls.
The default value is 2000 ms. The valid values range
from 1 to 2000 ms. Match this timer to the switch
configuration.
Release Guard Time (ms)
Specifies the delay between Cisco Business Edition
3000 receiving the seizure signal and sending the
seizure acknowledgment (ACK).
The default value is 2 ms. The valid values range from
2 to 2000 ms. Match this timer to the switch
configuration.
Seizure Ack Time (ms)
Outbound Call Routing Information
From the drop-down list, choose the discard digit
instructions to use for outbound call routing for the
PSTN connection.
Choose one of the following from the drop-down list
and click Save.
• Automatic—Select this option to use the digit
discard instructions based on the dial plan and
retain the system-default behavior.
• Set Manually—Select this option to customize
the digit discard instructions.
Click Edit to edit the digit discard instructions.
The digit discard instructions that appears
depend on the numbering plan that you choose
from the Dial Plan drop-down list on the System
Settings > Dial Plan > General tab. For
information on configuring the digit discard
instructions, see Digit Discard Instructions
Settings, on page 308.
Digit Discard Instruction
Inbound Call Routing Information
From the drop-down list, select the number of digits
that will be retained in the incoming called party
number.
Remove all but the last
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
OL-27022-01 301
Connection Settings

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes