DescriptionField
Click Save to save your changes.
A progress bar indicates the status of the site configuration. If
you refresh or open a new browser window to access the
Administrative interface while the site configuration is being
updated, a message displays that the system update is currently
in progress and the administrative interface will not be available
until the update is completed.
If there is a failure while updating the site, the system restarts
to recover. The failure indicates the problem with the system
configuration.
Cisco recommends that you contact the Cisco
Technical Assistance Center for assistance in case of
a failure.
Note
Save
Click Reset to discard your changes and display the saved data.Reset
Click OK to save your settings.
A progress bar indicates the status of the site configuration. If
you refresh or open a new browser to access the Administrative
Interface while the site is configured, a message appears
indicating that the system update is currently in progress and
the administrative interface will be unavailable until the update
completes.
If an error occurs while configuring the site, the system restarts
to recover. The failure indicates the problem with the system
configuration.
Cisco recommends that you contact the Cisco
Technical Assistance Center for assistance.
Note
OK
Click Cancel to cancel the configuration.Cancel
Configure Remote Site
This section describes how to configure a branch site. Remote sites represent physical locations where your
branch offices are located. Teleworker site represents a virtual location used to place users that do not work
at the central site or any remote site. You can configure multiple branch/remote sites in your system.
The following table describes the settings for remote sites, including branch offices and the teleworker site.
Table 83: Configure central and branch sites
DescriptionField
General Tab Information
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
OL-27022-01 339
Configure Remote Site
To Next Page
Loading...
