DescriptionField
Select this option to manually route the PSTN calls using a
custom dial plan. You can edit the dial plan pattern.
• Edit Dial Plan Patterns—Click to edit the dial plan
pattern for the PSTN connection.
For information about the settings on the dial plan
patterns page, see Dial Plan Pattern Settings, on page
355.
• Edit SPA Dial Plan—Click to edit the dial plan for the
SPA connection.
This link is not available if there is no SPA
connection type configured on your system.
Note
The Edit SPA Dial Plan window allows you to set the
number patterns that Cisco Business Edition matches
against the called numbers received from a SPA gateway
in order to determine whether to route the call. For
information about the settings on the dial plan patterns
page, see SPA Dial Plan Patterns, on page 358.
Route using a custom dial plan
From the drop-down list, select the outside dial code to use
for redial and click-to-call calls from this site.
Ensure that you select a valid connection group for
this outside dial code for the PSTN calls to work
correctly.
Note
Default Outside Dial Code
Call Quality Tab
Call Between Sites Information
Select the amount of span that you are leasing from your
service provider for your Internet and intranet connectivity.
Sites which operate with a network bandwidth less
than T1 to a central site are not supported for
point-to-point video calls.
Note
Bandwidth Between Sites
Check box to enable video calls between sites.
Point-to-point video is not supported within the
teleworker site or between the teleworker site and
any other site connected to the teleworker site.
Note
Video: Enable Video Calls Between Sites
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
OL-27022-01 345
Configure Remote Site
To Next Page
Loading...
