Then do this after you sign in...If you want to...
When placing a call, or transferring a call, using speed
dials, be aware of the following: if the destination
phone has roll-over lines enabled, on-hook/off-hook
illumination will apply only to the first appearance of
that line on the phone. For example, if the destination
number is 5000, and the line 5000 appears multiple
times on the destination phone—so that calls roll over
from the first appearance to the next when the first
appearance is busy—then only that first appearance is
monitored. If the user on the destination phone is on a
call using the second appearance of 5000, the speed
dial notices that the first appearance is not busy and
the light may not illuminate to indicate that line 5000
is busy.
NoteConfigure your Busy Lamp Feature (BLF)
When a speed-dial button is configured to
dial an internal number, the speed-dial
button light will illuminate when the
destination phone is picked up. It remains
lit until the other phone goes off hook. As
a result, the phone with the speed-dial
button can determine if the other party is
currently on the phone or not. Using this
feature, an attendant can monitor other
lines before transferring a call to that line.
Certain phone types, such as the Cisco
Unified IP Phone 6900 Series, have
softkeys on the screen, as opposed to
physical buttons on the phone. These
on-screen buttons are not compatible with
the Busy Lamp Feature (BLF) and
therefore do not show the presence of the
other party.
1
Check the Change Password check box.
2
Enter a password that does not contain spaces or
underscores.
3
Re-enter your password and click Save.
Reset your password for the Cisco
Business Edition 3000 User Preferences
Interface
1
Check the Change Phone PIN check box.
2
Enter a PIN that includes the digits 0 through 9.
3
Reenter your PIN and click Save.
Reset your phone PIN
You enter your phone PIN when you log
in to a Cisco Extension Mobility-enabled
phone. When you log into a Cisco
Extension Mobility-enabled phone, your
extension for line 1 is displayed, and your
speed dials may appear on the phone.
The Phone PIN settings are always
displayed, even if your system
administrator has not set up Cisco
Extension Mobility for you. Before you
attempt to use Cisco Extension Mobility,
verify with the local representative that
manages your phone system that you are
allowed to use Cisco Extension Mobility.
After you make your changes, click Save.Save
To discard your changes and display the saved data, click Reset.Reset
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
OL-27022-01 401
To Next Page
Loading...
