5 • Operation
Doc. 065031-04 1/08 149
Using the Application Wizard
1. Click Application Wizard on the Sequence Control panel.
2. Select a suppressor type (if used) and then select an application
template from the list.
NOTE Instead of selecting an application template, you can
use the Virtual Column Separation Simulator. Refer
to the Chromeleon Help for details.
3. Click Next> and select the in a new sequence via Sequence Wizard
option.
4. Click Next> to go to the Sequence Wizard.
5. Complete the steps in the Sequence Wizard, adding the desired
number of samples and standards to the list. For help at any time,
click the Help button on the Sequence Wizard page.
After you finish the Sequence Wizard, a sequence is created and a
program appropriate for the selected application is copied to the
sequence. If you are using Chromeleon, a quantification method is
also copied to the sequence
.
5.6.2 Starting Batch Sample Processing
1. Click Load Sequence on the Sequence Control panel.
A dialog box opens.
2. Select the sequence from the list and click Open (or Load if you are
using Chromeleon Xpress).
3. Click Start Batch on the Sequence Control panel.
To Next Page
Loading...
