Doc. 065031-04 1/08 227
TC Troubleshooting
8.29 Troubleshooting TC Error Messages
If any of the following alarm conditions occurs, a message is displayed in the
Chromeleon or Chromeleon Xpress Audit Trail.
This error occurs if the Chromeleon or Chromeleon Xpress program contains
an AcqOff command, but no AcqOn command.
To troubleshoot:
Every program should include one AcqOn command. Enter the AcqOn
command after the first injection.
This error occurs if a Chromeleon or Chromeleon Xpress program does not
include a command that ends data acquisition.
To troubleshoot:
The AcqOn command must be paired with an AcqOff command. Enter the
AcqOff command at the appropriate point in the program.
AcqOff without previous AcqOn.
Acquisition is still on at program end.
To Next Page
Loading...
