8 • Troubleshooting
Doc. 065031-04 1/08 171
8.1.2 EG Error Messages
The table below lists the EG-related error messages and their default
severity levels. For troubleshooting assistance, refer to the page indicated
in the table.
This function cannot be adjusted by the user. Abort page 196
Upper pressure limit exceeded. Abort page 196
EG-Related Audit Trail Error Message Default Severity
Level
See
CR-TC1 over current.
CR-TC2 over current.
Abort page 203
CR-TC1 stopped due to zero flow.
CR-TC2 stopped due to zero flow.
Abort page 203
EG1 cartridge disconnected.
EG2 cartridge disconnected.
Abort page 204
EG1 invalid concentration.
EG2 invalid concentration.
Abort page 204
EG1 invalid flow.
EG2 invalid flow.
Abort page 205
EG1 invalid flow rate-concentration.
EG2 invalid flow rate-concentration.
Abort page 205
EG1 over current.
EG2 over current.
Abort page 205
EG1 over power.
EG2 over power.
Abort page 206
EG1 over voltage.
EG2 over voltage.
Abort page 206
Leak sensor wet. Warning page 207
DP/SP-Related Audit Trail Error Message Default Severity
Level
See
To Next Page
Loading...
