ICS-3000 Ion Chromatography System
298 Doc. 065031-04 1/08
Use a tubing cutter to cut tubing to the required length. Make sure the cut is at a
right angle to the length of the tubing and there are no nicks or burrs on the end. A
tubing cutter (P/N 049584) is included in the DC Ship Kit (P/N 062614, dual;
P/N 063408, single). Refer to the instructions provided with the cutter.
9.18 Replacing the Leak Sensor
1. Turn off the pump flow from the Control panel in Chromeleon or Chromeleon
Xpress or press
PUMP FLOW on the front of the pump.
2. Press the
POWER button on the front of the DC to turn off the DC.
3. Open the DC lower door.
To avoid injury, wait for the DC to cool down before opening the door
or performing any maintenance or service procedures.
Afin d'éviter toute brûlure, laisser refroidir le DC avant d'ouvrir la
porte ou d'effectuer des opérations de maintenance.
Um Verletzungen zu vermeiden, warten Sie bitte, bis der DC abgekühlt
ist, ehe Sie die Tür öffnen bzw. Wartungs oder Servicearbeiten
durchführen.
To Next Page
Loading...
