Dionex ICS-3000 - DP;SP Error Messages

ICS-3000 Ion Chromatography System
170 Doc. 065031-04 1/08
8.1.1 DP/SP Error Messages
The table below lists the most frequently observed DP/SP-related error
messages and their default severity levels. For troubleshooting assistance,
refer to the page indicated in the table.
DP/SP-Related Audit Trail Error Message Default Severity
Level
See
A program with this name already exists. Abort page 189
Abnormal drive current for x.x seconds. Warning page 189
Camshaft index too early. Abort page 189
Camshaft index too late. Abort page 189
Camshaft sensor always alight. Abort page 190
Camshaft sensor missing or dark. Abort page 190
Degasser malfunction. Warning page 190
Excessive drive current. Camshaft x.x. Abort page 190
Invalid flow value. Abort page 191
Leak detected. Flow stopped. Abort page 191
Left-hand pump block carryover pressure is too high. Abort page 192
Motor malfunction. Abort page 192
Motor position error. The motor is overloaded. Abort page 192
Pressure fallen below lower limit. Abort page 193
Relay 4 is configured for inject synchronization. Please
change pump configuration.
Abort page 194
Right-hand pump block carryover pressure is too high. Abort page 192
The maximum purge pressure was exceeded. Abort page 194
The pressure in the left-hand working cylinder exceeded
the safety limit.
Abort page 194
The pressure in the right-hand working cylinder exceeded
the safety limit.
Abort page 194
The rear-seal leak count is x.x (counted drops) and has
exceeded the limit of y.y (leak detection threshold).
Warning page 195
The rear-seal leak sensor is malfunctioning. Warning page 196
The system pressure exceeded the safety limit. Abort page 194