8 • Troubleshooting
Doc. 065031-04 1/08 173
8.1.4 TC Error Messages
The table below lists the TC-related error messages and their default
severity levels. For troubleshooting assistance, refer to the page indicated
in the table.
Suppressor 1 open circuit.
Suppressor 2 open circuit.
Abort page 221
Upper door opened. Warning page 221
TC-Related Audit Trail Error Message Default Severity
Level
See
AcqOff without previous AcqOn. Error page 227
Acquisition is still on at program end. Error page 227
All samples scheduled for run on timebases x need to
specify the same value for property (nominal)
Temperature.
Error page 228
All samples scheduled for run on timebases x need to
specify the same value for property TempCtrl.
Error page 228
All samples scheduled for run on timebases x need to
specify the same value for property y.
Error page 228
Can't execute “Disconnect” command during data
acquisition.
Warning page 228
Can't execute “Standby” command during data
acquisition.
Warning page 228
Can't find download image TC3000.HEX. Abort page 229
Can't start acquisition at negative retention times. Error page 229
Can't start acquisition: The server configuration does not
fulfill the license conditions.
Abort page 229
Can’t start TC firmware. A firmware download may be
necessary.
Abort page 230
Can't use device “x” as a source of the column pressure.
Please check the property “SystemPressure” for a valid
device name. The device must have the “Pressure”
property available.
Error page 231
DC-Related Audit Trail Error Message Default Severity
Level
See
To Next Page
Loading...
