ICS-3000 Ion Chromatography System
174 Doc. 065031-04 1/08
Can't use device “x” as a source of the column pressure.
Please check the property “y” for a valid device name.
The device must have the “Pressure” property available.
Error page 231
Card data checksum error. Error page 231
Command is not available in demo mode. Abort page 232
Communication error: x. Abort page 232
Communication time-out. Abort page 232
Configuration doesn’t match. X not installed. Warning page 233
Configuration mismatch (x — CM uses y, Column
Compartment uses z). Please use the Server
Configuration program to check the installation.
Abort page 233
Current flow is out of limits defined for the column. Warning page 233
Current pressure is out of limits defined for the column. Warning page 233
Current temperature is out of limits defined for the
column.
Warning page 234
Data buffer overrun. Abort page 234
Device control feature is not available! Please check key
code and CM Features (see “About Chromeleon...” in the
client's Help menu).
Abort page 234
Device is not remote. Abort page 235
Device not found on the USB. Abort page 235
Either the current date is later than the expiration date for
x or the program or batch will end later than 24 hours
before the expiration time for y.
Warning page 236
Error deleting flash memory. Abort page 236
Error during storing of the card data to the chip card. Error page 236
Error finishing download. Abort page 230
Error programming flash memory. Abort page 237
Executing this command will reset associated counter
values stored in the module.
Warning page 237
Firmware download failed. Abort page 237
Firmware download in progress. Please wait. Error page 237
TC-Related Audit Trail Error Message Default Severity
Level
See
To Next Page
Loading...
