8 • Troubleshooting
Doc. 065031-04 1/08 175
Gas leak detected. Error page 238
Humidity leak detected. Error page 238
Illegal parameter. Abort page 238
Invalid date/time format. Either use “DD MMM YYYY” or
“current [ + [Nyear[s]] [Nmonth[s]] [Nday[s]]].” Examples:
“31 Dec 1999,” “current + 1year 6months.”
Error page 239
Invalid enumerated value. Warning page 239
Next qualification of this module is due in x day(s) (due
date is [date]).
Warning page 239
Next qualification of this module is overdue (due date
was [date]).
Warning page 239
Next qualification of this module is overdue (due date
was [date]). Module may no longer be used.
Error page 239
Next qualification of this module was due on [date].
Allowing x more grace day(s).
Warning page 239
Next service of this module is due in x day(s) (due date is
[date]).
Warning page 240
Next service of this module is overdue (due date was
[date]).
Warning page 240
No chip card in the reader for the column x. Error page 241
No response from x for x seconds. Warning page 241
No response from x for x seconds. Device disconnected. Abort page 241
Operating columns above 70 °C could affect column
performance. Verify recommended column operating
conditions before setting temperature above 70 °C.
Warning page 242
Parameter x value exceeded its allowed range. Set to
closest valid value y.
Warning page 242
Primary property “x” is already assigned and cannot be
changed.
Error page 243
Properties cannot be changed. A chip card has not been
inserted properly. Check the CardState property for all
cards and reinsert those indicating “BusBlocked.”
Error page 243
Properties cannot be changed if the compartment door is
open.
Error page 244
TC-Related Audit Trail Error Message Default Severity
Level
See
To Next Page
Loading...
