ICS-3000 Ion Chromatography System
176 Doc. 065031-04 1/08
Properties cannot be changed—there is no card in the
card reader.
Error page 244
Raw data file x cannot be created. Warning page 244
Raw data file x cannot be created. Continuing with
network failure protection.
Warning page 244
Raw data file x cannot be written. Warning page 244
Raw data file x cannot be written. Continuing with
network failure protection.
Warning page 244
Starting data acquisition manually will overwrite any data
which has been acquired so far.
Warning page 245
TC—Firmware download failed. Abort page 230
TC is not remote. Abort page 235
The command can format only chip cards with an invalid
data structure.
Error page 245
The communication interface is closed. Reconnect the
instrument.
Error page 245
The compartment door is open; a batch or a program
may need to wait until the door has been closed. Please
close the door.
Warning page 246
The counter [name] (value: x) has exceeded its limit (y).
Module should no longer be used. Replace the [name].
Warning page 246
The data format stored on the chip card is unsupported
(format version x).
Error page 246
The injections limit for the column has been exceeded. Warning page 247
The injections limit will be exceeded for the column x. Warning page 247
The nominal temperature must be set within the current
limits.
Error page 247
The nominal temperature value is out of range defined by
the active column ID.
Error page 247
The oven is not fully operable yet. Check the values of
“Standby,” “Ready,” “Door,” and “CardState.”
Error page 248
The primary column ID property “x” will be changed. The
property can't be changed in the future.
Warning page 248
TC-Related Audit Trail Error Message Default Severity
Level
See
To Next Page
Loading...
