TC Troubleshooting
Doc. 065031-04 1/08 247
Chromeleon and Chromeleon Xpress monitor the number of injections done
with each column and display an appropriate message (shown above) at the
following times: when the injections limit is about to be exceeded or has been
exceeded.
To troubleshoot:
Replace the column.
This error occurs if the selected TC temperature setting is outside the range
specified by the Temperature.LowerLimit and Temperature.UpperLimit
commands.
To troubleshoot:
Select a valid temperature setting.
This error occurs if the selected TC temperature setting is outside the range
specified by the Column_x.Temp_LowerLimit and Column_x.Temp_
UpperLimit commands.
To troubleshoot:
Select a valid temperature setting.
The injections limit for the column has been exceeded.
-or-
The injections limit will be exceeded for the column x.
The nominal temperature must be set within the current
limits.
The nominal temperature value is out of range defined by the
active column ID.
To Next Page
Loading...
