8 • EG Troubleshooting
Doc. 065031-04 1/08 211
3. Check that the main power cord is plugged into both the EG rear panel
connector and the power source. Check that the wall outlet has power.
4. Check the USB connections. The EG should be connected to the DP/SP
(or other ICS-3000 module) via a USB cable (P/N 960777). In addition,
one module in the system must be connected to the PC on which
Chromeleon or Chromeleon Xpress is installed.
5. Check that the EG is configured in Chromeleon or Chromeleon Xpress
and is assigned to a timebase.
To Next Page
Loading...
