DURKOPP ADLER 755 A

Programming
Service Instructions 755 A/756 A - 00.0 - 02/2019 269
5.1.7.5 Seam securement  p. 316
5.1.7.6 Additional thread tension  p. 314
5.1.8 Middle knife parameters  p. 318
Middle knife On/Off  p. 318
5.1.8.2 Speed middle knife  p. 318
5.1.8.3 Set middle knife correction seam begin.  p. 318
5.1.8.4 Set middle knife correction seam end  p. 318
5.1.8.5 Set loading position  p. 318
Automatic speed adjustment On/Off  p. 318
5.1.9 Corner knife (straight pocket)
Corner knife (slanted pocket, automatic)
Corner knife (slanted pocket, multi-functional)
 p. 320
 p. 322
 p. 325
5.1.9.2 Corner knife correction seam begin. (straight pocket)  p. 320
5.1.9.3 Corner knife correction seam end (straight pocket)  p. 320
5.1.9.8 Corner knife correction seam begin. left (slanted pocket,
automatic)
Set corner knife correction seam begin. left (slanted pocket,
multi-functional)
 p. 322
 p. 325
5.1.9.9 Corner knife correction seam begin. right (slanted pocket,
automatic)
Corner knife correction seam begin. right (slanted pocket,
multi-functional)
 p. 322
 p. 325
5.1.9.10 Corner knife correction seam end left (slanted pocket,
automatic)
Set corner knife correction seam end left (slanted pocket,
multi-functional)
 p. 323
 p. 326
5.1.9.11 Corner knife correction seam end right (slanted pocket,
automatic)
Corner knife correction seam end right (slanted pocket,
multi-functional)
 p. 323
 p. 326
5.1.9.12 Corner knife angle correction seam begin. left (slanted
pocket, multi-functional)
 p. 325
5.1.9.13 Corner knife angle correction seam begin. right (slanted
pocket, multi-functional)
 p. 325
5.1.9.14 Corner knife angle correction seam end left (slanted
pocket, multi-functional)
 p. 326
5.1.9.15 Corner knife angle correction seam end right (slanted
pocket, multi-functional)
 p. 326
5.1.10 Automatic tape feeder  p. 329
5.1.10.2 Set length of tape at seam begin.  p. 329
5.1.10.3 Set length of tape at seam end  p. 329
Menu item
Option/described
on page