DURKOPP ADLER 755 A

Programming
268 Service Instructions 755 A/756 A - 00.0 - 02/2019
5.0.2.1 Copy sequence  p. 290
5.0.2.0 Select source of sequence  p. 290
5.0.2.3 Select program  p. 283,
 p. 284
Piece counter  p. 279
Activate automatic sequence process  p. 293
5.1 Program parameters
5.1.1 Select pocket program  p. 296
5.1.2 Enter name of pocket program  p. 297
5.1.3 Copy pocket program  p. 297
5.1.4 Create/change seam program  p. 299
5.1.4.5 Set securement seam beginning left needle  p. 302
5.1.4.6 Set securement seam beginning right needle  p. 303
5.1.4.7 Set securement seam end left needle  p. 303
5.1.4.8 Set securement seam end right needle  p. 304
5.1.4.9 Select flap right/left  p. 301
5.1.4.10 Select positioning points  p. 301
5.1.4.11 Set stitch length main seam  p. 301
5.1.4.12 Activate flap  p. 306
5.1.5 Correction light barrier  p. 308
5.1.5.1 Correction seam begin.  p. 308
5.1.5.2 Correction seam end  p. 308
5.1.6 Marking lamps 1-16  p. 310
5.1.6.1 Activate marking lamps 1-16  p. 311
5.1.6.2 Set programmable marking lamps  p. 312
Set programmable marking lamp X-axis  p. 312
Set programmable marking lamp Y-axis  p. 313
5.1.7 Sewing head parameters  p. 314
5.1.7.1 Set sewing speed  p. 314
5.1.7.2 Set soft start parameters  p. 315
Continuous or intermittent transport  p. 314
5.1.7.4 Needle transport (756 A only)  p. 317
Menu item
Option/described
on page