EMC Connectrix DS-32M2 - Page 224

B
B-6 Connectrix DS-32M2 User Guide
Configuring Network Addresses
9. At the {U}> prompt, type ipconfig and press ENTER. The
HyperTerminal window appears with configuration information
listed as follows:
• MAC Address
• IP Address (default is 10.xxx.yyy.zzz)
• Subnet Mask (default is 255.0.0.0)
• Gateway Address (default is 0.0.0.0)
10. Change the IP address, subnet mask, and gateway address as
directed by the customer’s network administrator. To change the
switch network addresses, type the following at the {
U}> prompt
and press
ENTER.
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
The IP address is always xxx.xxx.xxx.xxx, the subnet mask is
always
yyy.yyy.yyy.yyy, and the gateway address is always
zzz.zzz.zzz.zzz, where the octets xxx, yyy, and zzz are
decimals, 0 through 255. If a network address is to remain
unchanged, type the current address in the respective field.
When the new network addresses are configured at the switch,
the message
Request completed OK appears at the bottom of the
HyperTerminal window.
11. Select the Exit option from the File pull-down menu to close the
HyperTerminal application. The following message box appears:
12. Click Yes. The following message box appears:
13. Click No to exit and close the HyperTerminal application.