D
D-32 Connectrix DS-32M2 User Guide
Command Line Interface
Parameters This command has one parameter.
Command Example
Root> config switch priority principal
config.switch.raTOV
Syntax raTOV timeoutValue
Purpose This command sets the R_A_TOV for the switch.
Description The switch must be off line before issuing this command. Use
maint.system.setOnlineState to set the switch off line.
Special care should be used when scripting this command due to its
relationship with E_D_TOV.
switchPriority
Specifies the switch priority. Valid values are:
principal, default, or neverprincipal:
◆ principal sets the numerical switch priority
to 1. The switch with a priority of 1 becomes
the principal switch; however, if two or
more switches have a priority of 1, the
switch with the lowest WWN becomes the
principal switch.
◆ default sets the numerical switch priority
to 254. If no switch is set to principal, the
switch with a priority 254 becomes the
principal switch; however, if two or more
switches have a priority of 254, the switch
with the lowest WWN becomes the
principal switch
◆ neverprincipal sets the numerical switch
priority to 255. This switch is not able to
become the principal switch.
At least one switch in a multiswitch fabric must have
a switch priority value of principal or default.
To Next Page
Loading...