D
CLI OverviewThe config Branch
D-45
Command Line Interface
config.zoning.showPending
Syntax showPending
Purpose This command shows the zoning configuration in the work area of
the zone set that has not yet been activated.
Parameters This command has no parameters.
Command Example
Root> config zoning showPending
Output The zoning configuration data is displayed as a table that includes
the enabled/disabled status, name, and member zones of the zone
set.
Output Example The output from config.zoning.showPending is similar to the
following:
Pending Zone Set
Default Zone Enabled: False
ZoneSet: TheNewUltimateZoneSet
Zone: TheNewUltimateZone
ZoneMember: Domain 10, Port 6
ZoneMember: Domain 15, Port 2
Zone: TheNewNotSoUltimateZone
ZoneMember: 10:00:00:00:C9:22:9B:AB
ZoneMember: 10:00:00:00:C9:22:9B:C6
ZoneMember: 10:00:00:00:C9:22:9B:AB
Zone: TheNewNotUltimateAtAllZone
ZoneMember: Domain 2, Port 63
config.zoning.showActive
Syntax showActive
Purpose This command shows the zoning configuration saved on the fabric.
Parameters This command has no parameters.
Command Example
Root> config zoning showActive
Output The zoning configuration data is displayed as a table that includes
the enabled/disabled status, name, and member zones of the zone
set.
To Next Page
Loading...