EMC Connectrix DS-32M2 - Page 311

D
perfshow
D-63
Command Line Interface
show.port.config
Syntax config
Purpose This command shows the port configuration for all ports.
Parameters This command has no parameters.
Command Example
Root> show port config
Output The port configuration attributes are displayed as a table that
includes the following properties.
◆ Port — The port number.
◆ Name — The name of the port as set in the config.port.name
command.
◆ Blocked — The blocked state of the port as set in the
config.port.blocked command.
◆ Ext Dist — The extended distance state as set in the
config.port.extDist command.
◆ Type — The port type as set in the config.port.type command.
◆ Speed — The port speed as set in the config.port.speed
command.
Output Example The output from show.system is similar to the following:
Port Name Blocked Ext Dist Type Speed
---- ------------------------ ------- -------- ----- ---------
0 Port 1 false false fPort 1 Gb/sec
1 Port 2 true true fPort 1 Gb/sec
2 Port 3 false false gPort 1 Gb/sec
3 Port 4 false false fPort 2 Gb/sec
4 Port 5 true true fPort 2 Gb/sec
5 Port 6 false false fPort 2 Gb/sec
6 Port 7 true true fPort 1 Gb/sec
7 Port 8 false false fPort Negotiate
8 Port 9 false true fPort 1 Gb/sec
9 Port A false false fPort 1 Gb/sec
10 Port B false false fPort 2 Gb/sec
11 Port C false false fPort 2 Gb/sec
12 Port D false false fPort 1 Gb/sec
13 Port E false false fPort 1 Gb/sec
14 Port F false false fPort 1 Gb/sec
15 Port X false false fPort 1 Gb/sec