EMC Connectrix DS-32M2 - Page 320

D
D-72 Connectrix DS-32M2 User Guide
Command Line Interface
show.zoning
Syntax zoning
Purpose This command shows the zoning configuration saved on the fabric.
Parameters This command has no parameters.
Command Example
Root> show zoning
Output The zoning configuration data is displayed as a table that includes
the enabled/disabled status, name, and member zones of the zone
set.
Output Example The output from show.zoning is similar to the following:
Active ZoneSet
-------------
Default Zone Enabled: False
ZoneSet: TheUltimateZoneSet
Zone: TheUltimateZone
ZoneMember: Domain 10, Port 6
ZoneMember: Domain 15, Port 2
ZoneMember: Domain 2, Port 63
ZoneMember: 10:00:00:00:C9:22:9B:64
ZoneMember: 10:00:00:00:C9:22:9B:BD
Zone: TheNotSoUltimateZone
ZoneMember: 10:00:00:00:C9:22:9B:AB
ZoneMember: 10:00:00:00:C9:22:9B:C6
ZoneMember: 10:00:00:00:C9:22:9B:AB
Zone: TheNotUltimateAtAllZone
ZoneMember: Domain 2, Port 63