3
Product Manager Menu Bar
3-15
Product Manager Overview
• Hardware Log — Displays information on FRUs inserted and
removed from the switch. Refer to Hardware Log on page 6-8.
• Link Incident Log — Displays the most recent incidents with
their date and time, port number, and description of the
incident.
Refer to Link Incident Log on page 6-9.
• Threshold Alert Log — Provides notifications of threshold
alerts, including date and time each alert occurred, port for
which the alert is configured, and type of alert (transmit
throughput, receive throughput, or both).
Refer to Threshold Alert Log on page 6-11.
◆ Maintenance:
• Port Diagnostics — Is used by service personnel to run
internal and external loopback tests on ports.
• Swap Ports (S/390 mode only) — Allows you to swap one
port address with another. Refer to Swapping Ports on page 7-3.
• Data Collection — Allows you to collect maintenance data
into a file. This file is used by support personnel to diagnose
system problems. Refer to Collecting Maintenance Data on
page 7-5.
• IPL — Allows you to initiate an Initial Program Load on the
switch Refer to Executing an IPL on page 7-6.
• Set Online State — Allows you to change the online state of
the switch to off line or on line. Refer to Setting the Online State
on page 7-8.
• Firmware Library — Displays all firmware versions currently
installed on the Connectrix service processor that can be
downloaded to the switch. Refer to Managing Firmware
Versions on page 7-9.
• Enable E-Mail Notification — Allows you to enable e-mail
notification for the switch. Refer to Enabling E-Mail Notification
on page 7-10.
• Enable Call Home Notification — Allows you to enable the
call-home function for the switch. Refer to Enabling Call-Home
Notification on page 7-11.
• Backup & Restore Configuration — Allows you to save the
product configuration stored on the switch to the Connectrix
service processor hard disk or to restore the product
To Next Page
Loading...