4
4-4
Connectrix DS-32M2 User Guide
Monitoring and Managing the Switch
Check the IP addresses, the Ethernet LAN physical connection
between the switch and Connectrix service processor, and other
network connection conditions.
◆ Link Timeout — The network connection that was established
between the switch and Connectrix service processor has been
lost. Check the IP addresses, the Ethernet LAN physical
connection between the switch and Connectrix service processor,
IP addresses, and other network components.
◆ Protocol Mismatch — The switch and the Connectrix service
processor are not at compatible software release levels. Update
the Connectrix Manager software version.
◆ Duplicate Session — A link has previously been established
between the switch and another instance of the Connectrix
service processor. Connect to the previously established
Connectrix service processor from the Connectrix Manager login
screen.
◆ Unknown Network Address — The address defined for the
switch in the Connectrix Manager could not be found in the
Domain Name Server (DNS). Either the name was mistyped
when the switch was added to the Connectrix Manager, or the
name was not available from the DNS. Check the network IP
address for the switch definition in the Connectrix Manager by
right-clicking the product icon and selecting Properties. The IP
address appears in the Network Address field.
◆ Incorrect Product Type — The product at the configured network
address is not a switch. Verify address, configuration, and
product type.
Status Symbol The status symbol in the lower left of the Hardware view indicates
the overall operating status of the switch. The status depends on
specific hardware component failures, which are indicated by status
symbols that appear over component graphics in the Hardware view.
Table 4-1 shows the alert panel symbols and their meanings.
To Next Page
Loading...
Need help?
General
