EasyManuals Logo

Fujitsu PRIMERGY RX1330 M1 Upgrade And Maintenance Manual

Fujitsu PRIMERGY RX1330 M1
312 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #123 background imageLoading...
Page #123 background image
RX1330 M1
Upgrade and Maintenance Manual 123
Hard disk drives / solid state drives
In order to permanently remove an operational HDD module that is part of a
RAID array from the server, you first need to delete the array using
ServerView RAID Manager.
V CAUTION!
All data on all HDDs/SSDs in the array will be lost! Be sure to back up
your data before deleting a RAID array.
For further information, please refer to the "ServerView Suite RAID
Management" user guide.
7.2.6.2 Removing a 2.5-inch HDD/SSD module
Ê Pinch the green locking clips and open the locking lever (see figure 56).
Ê Pull the HDD/SSD module out a few centimeters.
Ê Wait about 30 seconds to allow the hard disk drive to spin down.
I This is not necessary when removing a solid state drive.
I This period is necessary for the RAID controller to recognize that an
HDD module has been removed and for the hard disk drive to come
to a stop.
Ê Pull the HDD/SSD module completely out of its bay.
RAID 1
RAID 5
Removing an HDD module from a RAID 1 or RAID 5 array
will not result in data loss.
However, the removed drive needs to be replaced
immediately by an HDD module of the same or larger
capacity.
I After replacing the HDD module, RAID rebuild will
be performed as a background process as
described in section "Performing a RAID array
rebuild" on page 85.
RAID level Procedure

Table of Contents

Other manuals for Fujitsu PRIMERGY RX1330 M1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu PRIMERGY RX1330 M1 and is the answer not in the manual?

Fujitsu PRIMERGY RX1330 M1 Specifications

General IconGeneral
Number of Processors1
Memory Slots4
Maximum Memory32 GB
Form Factor1U Rack
ProcessorIntel Core i3 product family Intel Pentium product family
CPU FamilyIntel Xeon
Memory TypeDDR3 UDIMM
StorageUp to 4 x 3.5" or 2.5" drives
Drive Bays4
RAID0, 1, 5, 10
RAID ControllerOptional
Network2 x Gigabit Ethernet
Operating System SupportWindows Server, Red Hat Linux, SUSE Linux

Related product manuals