14.6.1.1 Preliminary steps
Ê "Locating the defective server" on page 43
Ê "Note on network settings recovery" on page 277
Ê "Disabling SVOM boot watchdog functionality" on page 64
Ê "Suspending BitLocker functionality" on page 63
Ê "Shutting down the server" on page 45
Ê "Disconnecting the server from the mains" on page 46
Ê Disconnect all external cables.
Ê "Getting access to the component" on page 47
Ê Remove all memory modules, see section "Removing a memory module" on
page 211.
I Before removing the memory modules, take a note on the installation
slot number for each memory module. Make sure that you reinstall
the memory modules in the slot they were located before the
replacement.
Ê Remove the heat sink, see section "Removing the heat sink" on page 215.
Ê Remove all expansion cards, see section "Expansion cards and riser cards"
on page 170.
I Before removing the expansion cards, take a note on the installation
slot number for each card. Make sure that you reinstall the card in the
slot it was located before the replacement.
Ê Remove the UFM (if applicable), see section "Removing the defective UFM"
on page 259.
I Remove the UFM spacer from the defective system board and fasten
it with the UFM screw to the UFM board.
Ê Remove the iRMC microSD card (if applicable), see section "Removing the
iRMC microSD card" on page 273.
To Next Page
Loading...
Need help?
General
