Fujitsu PRIMERGY RX1330 M1 Upgrade And Maintenance Manual

200 Upgrade and Maintenance Manual RX1330 M1
Expansion cards and backup units
9.5.4.5 Concluding steps
Ê "Reassembling" on page 52
Ê "Connecting the server to the mains" on page 55
Ê "Switching on the server" on page 57
9.5.5 Replacing a BBU
V CAUTION!
● Dispose of used battery properly. Keep away from children.
● Do not throw battery backup units into the trash can. Batteries must
be disposed of in accordance with local regulations concerning
special waste.
9.5.5.1 Preliminary steps
Ê "Disabling SVOM boot watchdog functionality" on page 64
Ê "Shutting down the server" on page 45
Ê "Disconnecting the server from the mains" on page 46
Ê "Getting access to the component" on page 47
9.5.5.2 Removing the defective BBU
Ê Remove the BBU with the holder as described in section "Removing the
BBU with the holder" on page 196.
Ê Remove the BBU from the holder as described in section "Removing the
BBU from the holder" on page 197.
Ê Disconnect the BBU cable from the BBU as described in section
"Disconnecting the BBU cable from the BBU" on page 197.
Upgrade and Repair Unit
(URU)
Hardware: 15 minutes
Tools: tool-less

Fujitsu PRIMERGY RX1330 M1 Specifications

General

Number of Processors	1
Memory Slots	4
Maximum Memory	32 GB
Form Factor	1U Rack
Processor	Intel Core i3 product family Intel Pentium product family
CPU Family	Intel Xeon
Memory Type	DDR3 UDIMM
Storage	Up to 4 x 3.5" or 2.5" drives
Drive Bays	4
RAID	0, 1, 5, 10
RAID Controller	Optional
Network	2 x Gigabit Ethernet
Operating System Support	Windows Server, Red Hat Linux, SUSE Linux