Ê Burn the image to a DVD.
Ê In order to create a bootable USB stick, please proceed as described in
the "Local System Update for PRIMERGY Servers" user guide.
Ê Before using the ServerView Update DVD or USB stick in an offline
environment, properly shut down the server and disconnect all external I/O
connections (like LAN, FC or SAS cables) from the system. Only keep
mouse, keyboard, video cable and AC power cord connected.
I Ensure that all external I/O connections are uniquely identified so that
you can reconnect them into their original locations after concluding
the task.
To start Update Manager Express from the (physical) Update DVD or from a
USB stick, proceed as follows:
Ê Prepare your Update DVD or USB stick as described in the "Local System
Update for PRIMERGY Servers" user guide.
Ê Boot the server from the prepared Update DVD or USB stick:
DVD: Ê Switch on the server.
Ê Right after switching on the server, insert the Update DVD into the
DVD drive and close the tray.
USB: Ê Connect the USB stick to the server.
Ê Switch on the server.
If the server does not boot from DVD or USB stick, proceed as follows:
Ê Reboot the server, e.g. by pressing the reset button on the front or
switching the server off and then on again after a few seconds.
Ê Once the server has been started, press [F12] to enter the boot menu.
Ê Use the Ê and Ë cursor keys to select your DVD drive or USB stick as
boot device and press [ENTER].
The server will now boot from the Update DVD or USB stick.
Ê After the boot process is complete, select your preferred GUI language.
The Update Manager Express main window will be displayed.
Ê Finish the intended maintenance task.
I For further information, refer to the "Local System Update for
PRIMERGY Servers" user guide.
To Next Page
Loading...
Need help?
General
