Fujitsu Server PRIMERGY TX1330 M1 User Manual

28 Upgrade and Maintenance Manual TX1330 M1
Before you start
2.4 Documents you need at hand
Maintenance procedures may include references to additional documentation.
When preparing the maintenance task, ensure that all required manuals are
available according to the overview below.
I – Ensure to store all printed manuals enclosed with your server in a
save place for future reference.
– Unless stated otherwise, all manuals are available online at
http://manuals.ts.fujitsu.com under x86 servers.
For the Japanese market please use the following address:
http://jp.fujitsu.com/platform/server/primergy/manual/
Document Description
"Quick Start Hardware -
PRIMERGY TX1330 M1" leaflet
Quick installation poster for initial operation,
available online
"ServerView Quick Start Guide"
"ServerView クイックスタート
ガイド " for the Japanese
market
Information on initial server setup and
software configuration, available online
"Safety notes and regulations"
manual
" 安全上のご注意 " for the
Japanese market
Important safety information, available
online, or as a printed copy
"FUJITSU Server PRIMERGY
TX1330 M1 Operating Manual"
available online
"D3239 BIOS Setup Utility for
FUJITSU Server PRIMERGY
TX1330 M1 Reference Manual"
Information on configurable BIOS options
and parameters, available online
System board and service labels
Labels inside the side / top server cover
outlining connectors, indicators and basic
maintenance tasks
Table 3: Documentation you need at hand

Fujitsu Server PRIMERGY TX1330 M1 Specifications

General

Memory Slots	4
Form Factor	Tower
Chipset	Intel C226
Processor Sockets	1
Processor	Intel Pentium, Intel Celeron
RAID Support	RAID 0, 1, 5, 10
Drive Bays	8 x 3.5-inch
Operating System Support	Windows Server, Red Hat, SUSE, VMware