Ê Close the locking bar (2) until it locks in place (3).
Ê Connect the front panel cable and the front USB cable to the system board
(see figure 154).
Ê Store both cables in the cable clamp (see figure 154).
13.1.4 Concluding steps
Ê "Installing the fan module" on page 152
Ê "Installing the rack front cover" on page 58 (rack server) or "Installing the
front cover" on page 63 (tower server)
Ê "Reassembling" on page 58
Ê "Connecting the server to the mains" on page 67
Ê "Switching on the server" on page 68
Ê "Verifying system information backup / restore" on page 79
Ê Store your server’s system information on the Chassis ID EPROM
integrated into the front panel board. For further information on how to obtain
and use the ChassisId_Prom Tool, refer to section "Using the Chassis ID
Prom Tool" on page 93.
Ê "Enabling SVOM boot watchdog functionality" on page 84
Ê "Enabling BitLocker functionality" on page 90
To Next Page
Loading...
