I Fujitsu does not assume responsibility for any damage done to the
server or for the loss of any data resulting from BIOS updates.
5.2.1.1 Updating or recovering the system board BIOS
BIOS flash procedure
Ê Perform the BIOS flash procedure as described in your server’s "BIOS
Setup Utility" reference manual.
BIOS recovery procedure
Ê Perform the BIOS recovery procedure as described in your server’s "BIOS
Setup Utility" reference manual.
5.2.1.2 Updating or recovering the iRMC
iRMC flash procedure
Ê Prepare a USB stick including the bootable iRMC firmware update image.
Ê Connect the USB stick to the USB port.
I Ensure that only the USB device with the iRMC firmware is connected
to the USB port. Remove all other USB devices temporarily.
Ê Restart the server.
Ê The system will detect the USB stick.
I If the BIOS cannot identify the USB stick, the pop-up message
Failed to boot for Emergency flash. Please Reset now.
will show up in the center of the screen.
Ê Choose one of the following options from the update tool menu to start the
iRMC update process:
Normal
Choose this option to update an existing system board.
Initial Choose this option if the system board has been replaced prior to the
iRMC update procedure. This option will perform all relevant flash
procedures in a row, including the iRMC firmware and bootloader.
To Next Page
Loading...
Need help?
General
