Fujitsu Server PRIMERGY TX1330 M1 User Manual

128 Upgrade and Maintenance Manual TX1330 M1
Hard disk drives / solid state drives
7.2.4.3 Installing a 2.5-inch HDD / SSD dummy module
V CAUTION!
If the removed HDD / SSD module is not replaced immediately, always
replace a dummy module into the unused HDD / SSD bay to comply with
applicable EMC regulations and satisfy cooling requirements.
Figure 48: Installing a 2.5-inch HDD / SSD dummy module
Ê Slide the HDD dummy module into the drive bay until it locks in place.
7.2.4.4 Concluding steps
Ê If applicable, "Installing the HDD bay cover" on page 64

Fujitsu Server PRIMERGY TX1330 M1 Specifications

General

Memory Slots	4
Form Factor	Tower
Chipset	Intel C226
Processor Sockets	1
Processor	Intel Pentium, Intel Celeron
RAID Support	RAID 0, 1, 5, 10
Drive Bays	8 x 3.5-inch
Operating System Support	Windows Server, Red Hat, SUSE, VMware