Ê Connect the power connector P1 to system board connector "PWR1" (2)
(see section "Cabling plans" on page 303).
Ê Route the power cables in the corresponding cable clamps (see circles).
Ê Install the power supply unit(s) as described in "Installing a hot-plug power
supply unit" on page 108.
Ê If one bay remains empty, install the dummy cover as described in "Installing
the dummy cover" on page 111.
6.4.4 Concluding steps
Ê "Installing the fan module" on page 152
Ê "Reassembling" on page 58
Ê "Connecting the server to the mains" on page 67
Ê "Switching on the server" on page 68
Ê "Enabling BitLocker functionality" on page 90
To Next Page
Loading...
