Fujitsu Server PRIMERGY TX1330 M1 User Manual

TX1330 M1 Upgrade and Maintenance Manual 285
System board and components
14.5.5 Concluding steps
Ê Reconnect all cables to the system board. For a complete cabling overview,
please refer to section "Cabling plans" on page 303.
Ê Reinstall all remaining system board components as shown in the related
sections:
– Heat sinks: refer to section "Installing the processor heat sink" on
page 225
– Memory modules: refer to section "Installing a memory module" on
page 213
I Install all memory modules into their original slots.
– Expansion cards: refer to section "Installing a memory module" on
page 213
I Install all expansion cards into their original slots.
– UFM (if applicable): refer to section "Installing the UFM" on page 257
– TPM (if applicable): refer to section "Installing the TPM" on page 264
Ê "Installing the fan module" on page 152
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
corresponding BIOS Setup Utility reference manual.
Ê "Reassembling" on page 58
Ê Reconnect all external cables.
Ê "Connecting the server to the mains" on page 67
Ê "Switching on the server" on page 68
Ê "Updating or recovering the system board BIOS and iRMC" on page 76
Ê "Verifying system information backup / restore" on page 79
Ê If customer BIOS settings are not restored automatically, please change the
settings manually (using the information collected during "preliminary
steps"). If you couldn't determine the BIOS version, ask the customer to
reconfigure all BIOS settings and the password.

Fujitsu Server PRIMERGY TX1330 M1 Specifications

General

Brand	Fujitsu
Model	Server PRIMERGY TX1330 M1
Category	Server
Language	English