Fujitsu Server PRIMERGY TX1330 M1 User Manual

212 Upgrade and Maintenance Manual TX1330 M1
Main memory
10.2.2 Removing a memory module
Ê Identify the desired memory slot see section "Memory sequence" on
page 210.
V CAUTION!
Ensure to maintain an operational configuration when removing
memory modules. For additional information, please refer to section
"Basic information" on page 209.
Figure 123: Removing memory modules
Ê Eject the desired memory module by pressing out the securing clips at each
end of the memory slot (1).
Ê Remove the ejected memory module (2).
10.2.3 Concluding steps
Ê "Installing the fan module" on page 152
Ê "Reassembling" on page 58
Ê "Connecting the server to the mains" on page 67
Ê "Switching on the server" on page 68
Ê If applicable, "Updating or recovering the system board BIOS and iRMC" on
page 76
Ê "Enabling SVOM boot watchdog functionality" on page 84
Ê "Enabling BitLocker functionality" on page 90

Fujitsu Server PRIMERGY TX1330 M1 Specifications

General

Memory Slots	4
Form Factor	Tower
Chipset	Intel C226
Processor Sockets	1
Processor	Intel Pentium, Intel Celeron
RAID Support	RAID 0, 1, 5, 10
Drive Bays	8 x 3.5-inch
Operating System Support	Windows Server, Red Hat, SUSE, VMware