Fujitsu Server PRIMERGY TX1330 M1 User Manual

TX1330 M1 Upgrade and Maintenance Manual 203
Expansion cards and backup units
9.5.6 Replacing an FBU
V CAUTION!
Do not throw FBUs into the trash can. Batteries must be disposed of in
accordance with local regulations concerning special waste.
For further safety information, please refer to section "Environmental
protection" on page 41.
9.5.6.1 Preliminary steps
Ê "Locating the defective server" on page 43
Ê "Disabling SVOM boot watchdog functionality" on page 70
Ê "Shutting down the server" on page 46
Ê "Disconnecting the server from the mains" on page 46
Ê "Getting access to the component" on page 47
Ê "Removing the fan module" on page 151
9.5.6.2 Removing the defective FBU
Ê Remove the FBU with the holder as described in section "Removing an
FBU" on page 200.
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: tool-less

Fujitsu Server PRIMERGY TX1330 M1 Specifications

General

Memory Slots	4
Form Factor	Tower
Chipset	Intel C226
Processor Sockets	1
Processor	Intel Pentium, Intel Celeron
RAID Support	RAID 0, 1, 5, 10
Drive Bays	8 x 3.5-inch
Operating System Support	Windows Server, Red Hat, SUSE, VMware