Fujitsu Server PRIMERGY TX1330 M1 User Manual

TX1330 M1 Upgrade and Maintenance Manual 227
Processors
11.2.7 Concluding steps
Ê "Installing the fan module" on page 152
Ê "Reassembling" on page 58
Ê "Connecting the server to the mains" on page 67
Ê "Switching on the server" on page 68
Ê If applicable, "Updating or recovering the system board BIOS and iRMC" on
page 76
Ê "Enabling SVOM boot watchdog functionality" on page 84
Ê "Enabling BitLocker functionality" on page 90
11.3 Replacing the processor heat sink
11.3.1 Preliminary steps
Ê "Locating the defective server" on page 43
Ê "Shutting down the server" on page 46
Ê "Getting access to the component" on page 47
Ê "Removing the fan module" on page 151
11.3.2 Replacing the processor heat sink
Ê Remove the processor heat sink as described in section "Removing the
processor heat sink" on page 219.
Ê Apply thermal paste to the processor surface as described in section
"Applying thermal paste" on page 223.
Field Replaceable Unit
(FRU)
Hardware: 15 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver

Fujitsu Server PRIMERGY TX1330 M1 Specifications

General

Memory Slots	4
Form Factor	Tower
Chipset	Intel C226
Processor Sockets	1
Processor	Intel Pentium, Intel Celeron
RAID Support	RAID 0, 1, 5, 10
Drive Bays	8 x 3.5-inch
Operating System Support	Windows Server, Red Hat, SUSE, VMware