EasyManua.ls Logo

Fujitsu Server PRIMERGY TX1330 M1 - Removing the Defective Memory Module; Installing the New Memory Module; Concluding Steps

Fujitsu Server PRIMERGY TX1330 M1
336 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TX1330 M1
Upgrade and Maintenance Manual 215
Main memory
Ê "Disconnecting the server from the mains" on page 46
Ê "Getting access to the component" on page 47
Ê "Removing the fan module" on page 151
Ê Locate the defective memory module using the onboard Local Diagnostic
LEDs (see section "Onboard indicators and controls" on page 324).
10.4.2 Removing the defective memory module
Ê Remove the memory module as described in section "Removing a memory
module" on page 212.
10.4.3 Installing the new memory module
Ê Install the memory module as described in section "Installing a memory
module" on page 213.
10.4.4 Concluding steps
Ê "Installing the fan module" on page 152
Ê "Reassembling" on page 58
Ê "Connecting the server to the mains" on page 67
Ê "Switching on the server" on page 68
Ê If applicable, "Updating or recovering the system board BIOS and iRMC" on
page 76
Ê "Enabling SVOM boot watchdog functionality" on page 84
Ê "Enabling replaced components in the system BIOS" on page 85
Ê "Verifying the memory mode" on page 85
Ê "Enabling BitLocker functionality" on page 90

Table of Contents

Related product manuals