14. HOW TO MONITOR ROUTES
14-5
No. Item Description
1 [To WPT], [GO]
button
The system selects a next waypoint automatically. Check that the To way-
point is the desired one. The system will automatically advance to a next
waypoint when you pass the To waypoint. The default [To WPT] is WPT2.
If you desire a different one, select it here and the click the [GO] button.
[Distance] Distance from current position to selected waypoint.
[Departure] The time the route was selected for monitoring.
[Actual Average
SPD]
The average speed over the ground, measured every 30 seconds.
2 Waypoint list The waypoint list provides for each waypoint WPT no., name, latitude and
longitude position, ETA, plan speed, bearing and distance to leg*, steering
mode ([Rhumbline] or [Greatcircle]), radius, XTD limit, speed max, margin
and local time.
*: The bearing to a leg and the display method for leg distance can be
changed. For details, see paragraph 12.4.1. Can be changed. See
"Leg/NM" on page 12-5.
3 [Check ETA]
window
Parameters for checking ETA. The arrow to the left of [Check ETA] col-
lapse or display the [Waypoints], [Linked User Chart] and [Check Results
]tabs.
[WPT],
[Distance]
Select a WPT to find the distance to that waypoint from current position.
[Plan] The ETA to the selected waypoint if the planned speed is maintained
[Actual] The ETA to the selected waypoint if current speed is maintained.
[To Localtime] Switch between UTC and local time for ETA. For local time, the settings
used in the creation of the route are used for the ETA calculation. See
section 12.4.1.
[Off Plan] The time difference between planned ETA and calculated ETA to final
WPT, when different. The indication is prefixed with "-" if earlier than
planned; "+" if later than planned.
[SPD Calcula-
tion]
Enter speed and ETA (time and date) to find the speed to use to arrive by
the ETA.
[Start Calculate]
button
Click to start calculation. The button label changes to [Stop Calculate].
[Suggested
SPD]
The system calculates suggested speed so that ETA to the WPT selected
would be same as planned ETA if type of optimization was "Time table".
4 [Total WPTs] The total number of waypoints in the route.
[Total Distance] The total distance of the route.
To Next Page
Loading...
