30. Alerts
30-9
Alert number 363: ROUTE: SELECT DISABLED /4
------------------------------------
A NEW ROUTE CANNOT BE SELECTED DURING
ROUTE STEERING. USE 'RADIUS CONTROL'
TO OVERRIDE ROUTE STEERING BEFORE
CHOOSING A NEW ROUTE.
Alert number 364: ROUTE: CANCEL DISABLED /6
------------------------------------
A ROUTE CANNOT BE CANCELED DURING
ROUTE STEERING. USE 'RADIUS CONTROL'
TO OVERRIDE ROUTE STEERING BEFORE
CANCELING THE ROUTE.
Alert number 365: MANUAL GYRO NOT SELECTED /4
------------------------------------
SELECT MANUAL HEADING IN SENSORS
SPD/HDG PAGE.
Alert number 366: MANUAL SPEED NOT SELECTED /4
------------------------------------
SELECT MANUAL SPEED IN SENSORS
SPD/HDG PAGE.
Alert number 367: MANUAL DRIFT DISABLED /4
------------------------------------
MANUAL DRIFT VALUE CAN ONLY BE
INSERTED WHEN NO SENSORS PROVIDE
SPEED OVER GROUND DATA.
USE 'SENSORS' BUTTON TO VERIFY
AND SELECT SENSORS TO BE USED.
Alert number 371: RADAR SOURCE CHANGE /5
------------------------------------
MASTER RADAR FOR ECDIS HAS BEEN
CHANGED. VERIFY NEW SOURCE OR
TRACKED TARGETS
Alert number 372: CHARTALIGN: NO LINE AVAIL /3
------------------------------------
TO PERFORM CHART ALIGN WITH A
RADAR THERE MUST BE TRANSFERRED USER
CHART'S LINES IN THE RADAR.
CHECK THAT YOUR CURRENT USER CHART
HAS LINES AND THAT THEY ARE VISIBLE
ON RADAR DISPLAY
Alert number 380: USERCHART: FILE READ ERR /4
------------------------------------
CANNOT READ USER CHART IN MONITOR
MODE. MOVE USER CHART TO PLAN MODE
TO MAKE POSTPROCESSING AGAIN FOR
USER CHART.
To Next Page
