Furuno FEA-2807 - 4. Display Mode

FURUNO FEA-2107/2807 Series
E4122S02E
SP-2
Others: Own ship position in lat/lon, speed, course, waypoint
information, route monitoring Information, chart Information in
use, several alarm Information
4. Display Mode True motion north up, True motion, course up, Relative motion
north up, Relative motion course up, Relative motion head up
Relative motion route up
5. Other Display Features - Chart zoom in and zoom out
- EBL, VRM, parallel cursor
- One touch activation of standard display
- Selection of symbol, etc.
- Electronic chart update
- AIS safety message
-Navtex message
- AIS own ship info
6. User Chart - User chart creation (max. 2000 lines, max 1000 symbols)
- User chart overlayed on electronic map
- User chart may be transferred to radar screen
7. Position Calculation - Navigation by results of positioning found with external sensor
- Dead reckoning with gyro and log
- Highly accurate position with combination of gyro, log,
external Sensor and Kalman filter
8. Navigation Planning - Planning by Rhumb line, Great circle
- Route creation
- Route data may be transferred to radar
9. Automatic Navigation - Automatic navigation with Trackpilot (option)
10. Route Monitoring - Off-track display
- Waypoint arrival alarm
- Shallow depth alarm
11. Navigation Recording - Latest 12 hours of navigation data may be recorded
(time, position, position correction value, bearing, speed, etc.)
12. Pilot Data - Creation and display of pilot data
- Pilot data may be transferred to radar (radar must be able to
display such data)
13. Other Features - MOB (Man Overboard)
(Position, etc. at time of man overboard are recorded and
MOB mark is displayed on the screen)
14. Data I/O Interface Standard interface
- Gyro interface: serial data (IEC 61162-1 HDT)
- Speed log: serial data (IEC 61162-1 VBW)
- Position sensor: serial data (IEC 61162-1(or 2) GLL, VTG,
ZDA) GPS, DGPS, Lora C, etc., two units)
- Radar: ARPA, two units
- Alarm output: Relay contact signal (Short: alarm generated)