Archiving
10-8 Vivid S70 / S60 – User Manual
BC092760-1EN
01
Storing a cineloop
A cineloop is a sequence of images recorded over a certain time
frame. The time frame can be adjusted to cover one or more
heart cycles. The stored cineloops are displayed chronologically
on the clipboard. Cineloops can be stored at any time during the
scanning session.
The system can be configured to perform either
• Retrospective storage: while scanning press Store to store
the last elapsed defined number of cycles/seconds.
• Prospective storage: while scanning press Store to start
storage of the forthcoming defined number of cycles/
seconds.
The user can also configure the system to preview the cineloop
before storage or save the cineloop directly as described in the
sections below.
See ‘Global imaging settings’ on page 12-17 for configuration of
cineloop storage.
Direct storage of a cineloop
Depending on whether the system has been configured to
enable or disable the Preview Loop before store function (see
‘Global imaging settings’ on page 12-17), the following
procedures enable the cineloop to be stored directly.
Storing cineloop without preview
The function Preview Loop before store is disabled (see
page 12-17).
1. Press Store mode rotary/push button on the Touch panel to
select between cycles and time storage and adjust Num
Cycles or Timespan to define the number of cycles or
seconds to store.
2. While scanning, press Store.
• If Retrospective storage is selected (see page 12-17),
the last elapsed defined number of cycles/seconds are
stored.
• If Prospective storage is selected (see page 12-17),
the forthcoming defined number of cycles/seconds are
stored.
A thumbnail is displayed on the clipboard and scanning
resumes immediately.
To Next Page
Loading...
