Customize Configuration
12-72 Vivid S70 / S60 – User Manual
BC092760-1EN
01
2. Select a removable media or a network volume remote path
as the destination in the Destination pull-down menu.
3. If Remote path is selected, enter the remote path and press
Check to verify the connection.
4. Select OK and press Config.
Patient ID
Figure 12-55. The Patient ID sheet
The following settings related to patient id can be adjusted:
Setting Description
Automatic generation of patient ID In the Archive screen (see Figure 10-5 on page 10-15),
: A Patient ID is automatically generated by the
system.
: A Patient ID is required and must be entered by the
user when creating a new patient record in the archive.
Issuers of patient ID In the Archive screen (Figure 10-5 on page 10-15), the
issuer of a patient id may be specified for a patient id.
An issuer may be added, modified, or deleted.
The issuer set as default will be used as issuer for all
new patients that are created.
In addition, in transfer between remote and local
archive, two patients with same patient id, one with
empty issuer and one with default issuer, are
considered the same patient.
To Next Page
Loading...
