GE Vivid S60 User Manual

Measurement Package
Vivid S70 / S60 – User Manual 12-21
BC092760-1EN 01
Measurement package configuration - example
The following example based on calculation of AV CO (Cardiac
Output by Aortic Flow) describes how to configure the
measurement package so that necessary measurements and
the resulting calculations are displayed on screen.
Calculation of Cardiac Output by Aortic Flow requires the
measurement of:
• AV diameter located in the folder Dimension (2D mode)
• AV VTI located in the folder Aortic (Doppler AV Trace).
• Heart rate
If a calculated parameter (e.g. AV CO in AV Trace
measurement) requires another parameter to be calculated (e.g.
AV Diam) the user must first measure the required parameter
(e.g. AV Diam) before the dependent parameter (e.g AV CO in
AV Trace) gets calculated.
Configuration of the Measurement menu
If the AV diameter measurement is not present in the folder
Dimension in the Measurement menu, follow the following
procedure:
1. Press Utility/Config on the Touch panel and select the
category Measure/Text.
The Measurement menu sheet is displayed (Figure 12-10).
2. AV Diam is a 2D measurement, make sure that 2D is
checked in the Measurement sheet.
3. Select folder Dimension in the Measurement menu.
A list of all available measurements for the selected folder is
displayed in the Measurement menu sheet.
4. Check the box in front of AV Diam.
The AV Diam measurement is displayed in the folder
Dimension in the Measurement menu.
5. For the AV VTI measurement, check Doppler in the
Measurement menu sheet and select the folder Aortic in
the Measurement menu.
6. Check the box in front of AV Trace.
The AV Trace measurement is displayed in the folder Aortic
in the Measurement menu.

GE Vivid S60 Specifications

General

Brand	GE
Model	Vivid S60
Category	Medical Equipment
Language	English