Scan Assist Pro
Vivid S70 / S60 – User Manual 5-61
BC092760-1EN 01
Setting up Scan Assist Pro
Scan Assist Pro is ready to use with factory Protocols. However
user-defined Protocols customized to better suit the user’s
needs can be added to the list of available Protocols on the Vivid
S70 / S60.
User-defined Protocols are created using the Scan Assist Pro
Creator program, either on-system or off-system (see ‘Scan
Assist Pro Creator’ on page 12-75).
To set up Scan Assist Pro with user-defined Protocols you need
to:
• Import the user-defined Protocol that was created using the
Scan Assist Pro Creator.
NOTE: You do not need to import the user-defined Protocol if it was
created with the on system Scan Assist Pro Creator
program.
• Add the Protocol to the Protocol selection so that it is
available from the Touch panel.
Importing a Protocol
1. Insert the media with the saved Protocol from the Scan
Assist Pro Creator or exported Protocol from another Vivid
S70 / S60.
Refer to ‘Scan Assist Pro Creator’ on page 12-75 for more
information on how to create a Protocol.
2. Press Utility/Config on the Touch panel and log on if
required.
3. Select Imaging/Scan Assist Pro.
To Next Page
Loading...
