Safety
2-22 Vivid S70 / S60 – User Manual
BC092760-1EN
01
Electromagnetic emissions
The Vivid S70 / S60 is intended for use in the electromagnetic
environment specified below. The customer or the user of the
Vivid S70 / S60 should ensure that it is used in such an
environment.
Electromagnetic immunity
The Vivid S70 / S60 is intended for use in the electromagnetic
environment specified below. The customer or the user of the
Vivid S70 / S60 should ensure that it is used in such an
environment,
Portable RF communications equipment (including peripherals
such as antenna cables and external antennas) should be
used no closer than 30 cm (12 inches) to any part of the Vivid
S70 / S60 series system, including cables specified by the
manufacturer. Otherwise, degradation of the performance of
this equipment could result.
Guidance and manufacturer’s declaration – electromagnetic emissions.
Emissions test Compliance Electromagnetic environment - guidance
RF emission
CISPR 11
Group 1 The ultrasound system uses RF energy only for its
internal function. Therefore, its RF emissions are very
low and are not likely to cause any interference in nearby
electronic equipment.
RF emission
CISPR 11
EN55011
Class A This system is suitable for use in all establishments,
other than domestic establishments and those directly
connected to the public low-voltage power supply
network that supplies buildings used for domestic
purposes, provided the following warning is heeded:
Warning: This system is intended for use by healthcare
professionals only. This system may cause radio
interference or disrupt the operation of nearby
equipment. It may be necessary to take mitigating
measures, such as re-orienting or relocating the system
or shielding the location.
Harmonic emission
IEC 61000-3-2
Class A
Voltage fluctuations/flicker
emissions
IEC 61000-3-3
Complies
To Next Page
Loading...
